There is NO industry standard data for Mode $06 test. It allows access to test results for on-board diagnostic monitoring tests of specific components that are continuously monitored (misfire monitoring) and non-continuously monitored systems. When you enter this mode, you choose which system you want to monitor. When you enter this mode, you are telling the PCM/ECM to provide access to on-board monitoring test results for specific monitored systems. For those cars, you’ll need to go directly to Mode $06. The difference is that Mode $05 information is not available on vehicles using the Controller Area Network (CAN) system. You can obtain the same information by using Mode $06. When you enter this mode you get access to the engine control module’s oxygen sensor monitoring test results. When you enter this mode, you are telling the PCM/ECM to provide oxygen sensor monitoring test results. It also resets all readiness monitors and turns off the check engine light. When you enter this mode, you’re clearing not only the trouble codes, but also the freeze-frame data and all stored test data. When you enter this mode, you are telling the PCM/ECM to clear/reset emissions-related diagnostic information. The purpose of Mode $03 is to allow your scan tool to access codes stored in the emissions-related modules. When you enter this mode, you are telling the PCM/ECM to provide emissions related trouble codes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |